[PATCH] spi/altera_spi: Add cs_change support

[Franck Jullien <franck.jullien@gmail.com>]

The Linux kernel says (spi.h) :

* All SPI transfers start with the relevant chipselect active.  Normally
* it stays selected until after the last transfer in a message.  Drivers
* can affect the chipselect signal using cs_change.
*
* (i) If the transfer isn't the last one in the message, this flag is
* used to make the chipselect briefly go inactive in the middle of the
* message.  Toggling chipselect in this way may be needed to terminate
* a chip command, letting a single spi_message perform all of group of
* chip transactions together.
*
* (ii) When the transfer is the last one in the message, the chip may
* stay selected until the next transfer.  On multi-device SPI busses
* with nothing blocking messages going to other devices, this is just
* a performance hint; starting a message to another device deselects
* this one.  But in other cases, this can be used to ensure correctness.
* Some devices need protocol transactions to be built from a series of
* spi_message submissions, where the content of one message is
* determined by the results of previous messages and where the whole transaction
* ends when the chipselect goes intactive.

In other words, cs_change changes the default chipselect *behavior*.

Support of cs_change is necessary to implement the mci spi driver.

This patch also fix few things:

Passing the bus number to the brand new master device.
Disable chipselect during master->setup.

Signed-off-by: Franck Jullien <franck.jullien@gmail.com>
---
 drivers/spi/altera_spi.c |   27 ++++++++++++++++++++++++++-
 1 files changed, 26 insertions(+), 1 deletions(-)

diff --git a/drivers/spi/altera_spi.c b/drivers/spi/altera_spi.c
index 4fd82fb..d63dce3 100644
--- a/drivers/spi/altera_spi.c
+++ b/drivers/spi/altera_spi.c
@@ -25,6 +25,9 @@
 #include <io.h>
 #include <asm/spi.h>
 #include <asm/nios2-io.h>
+#include <clock.h>
+
+static void altera_spi_cs_inactive(struct spi_device *spi);
 
 static int altera_spi_setup(struct spi_device *spi)
 {
@@ -49,6 +52,8 @@ static int altera_spi_setup(struct spi_device *spi)
 		return -1;
 	}
 
+	altera_spi_cs_inactive(spi);
+
 	dev_dbg(master->dev, " mode 0x%08x, bits_per_word: %d, speed: %d\n",
 		spi->mode, spi->bits_per_word, altera_spi->speed);
 
@@ -167,19 +172,38 @@ static int altera_spi_transfer(struct spi_device *spi, struct spi_message *mesg)
 	struct altera_spi *altera_spi = container_of(spi->master, struct altera_spi, master);
 	struct nios_spi *nios_spi = altera_spi->regs;
 	struct spi_transfer *t;
+	unsigned int cs_change;
+	const int nsecs = 50;
 
 	altera_spi_cs_active(spi);
 
+	cs_change = 0;
+
 	mesg->actual_length = 0;
 
 	list_for_each_entry(t, &mesg->transfers, transfer_list) {
+
+		if (cs_change) {
+			ndelay(nsecs);
+			altera_spi_cs_inactive(spi);
+			ndelay(nsecs);
+			altera_spi_cs_active(spi);
+		}
+
+		cs_change = t->cs_change;
+
 		mesg->actual_length += altera_spi_do_xfer(spi, t);
+
+		if (cs_change) {
+			altera_spi_cs_active(spi);
+		}
 	}
 
 	/* Wait the end of any pending transfer */
 	while ((readl(&nios_spi->status) & NIOS_SPI_TMT) == 0);
 
-	altera_spi_cs_inactive(spi);
+	if(!cs_change)
+		altera_spi_cs_inactive(spi);
 
 	return 0;
 }
@@ -199,6 +223,7 @@ static int altera_spi_probe(struct device_d *dev)
 	master->setup = altera_spi_setup;
 	master->transfer = altera_spi_transfer;
 	master->num_chipselect = pdata->num_chipselect;
+	master->bus_num = pdata->bus_num;
 
 	altera_spi->regs = dev_request_mem_region(dev, 0);
 	altera_spi->databits = pdata->databits;
-- 
1.7.7


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox