[PATCH 4/4] at91sam9x5ek: add mci support

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

only add mci0 (microSD slot) as mci1 conflict with spi0

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
---
 arch/arm/boards/at91sam9x5ek/init.c     |   20 ++++++++++++++++++++
 arch/arm/configs/at91sam9x5ek_defconfig |    5 +++--
 2 files changed, 23 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boards/at91sam9x5ek/init.c b/arch/arm/boards/at91sam9x5ek/init.c
index d97da2b..4b3c099 100644
--- a/arch/arm/boards/at91sam9x5ek/init.c
+++ b/arch/arm/boards/at91sam9x5ek/init.c
@@ -115,6 +115,25 @@ static void ek_add_device_eth(void)
 	at91_add_device_eth(0, &macb_pdata);
 }
 
+/*
+ * MCI (SD/MMC)
+ */
+/* mci0 detect_pin is revision dependent */
+static struct atmel_mci_platform_data mci0_data = {
+	.bus_width	= 4,
+	.detect_pin	= AT91_PIN_PD15,
+	.wp_pin		= 0,
+};
+
+static void ek_add_device_mci(void)
+{
+	if (at91sam9x5ek_cm_is_vendor(VENDOR_COGENT))
+		mci0_data.detect_pin = 0;
+
+	/* MMC0 */
+	at91_add_device_mci(0, &mci0_data);
+}
+
 struct qt1070_platform_data qt1070_pdata = {
 	.irq_pin	= AT91_PIN_PA7,
 };
@@ -225,6 +244,7 @@ static int at91sam9x5ek_devices_init(void)
 	ek_add_device_nand();
 	ek_add_device_eth();
 	ek_add_device_spi();
+	ek_add_device_mci();
 	at91_add_device_usbh_ohci(&ek_usbh_data);
 	ek_add_led();
 	ek_add_device_i2c();
diff --git a/arch/arm/configs/at91sam9x5ek_defconfig b/arch/arm/configs/at91sam9x5ek_defconfig
index 5b17002..354cf08 100644
--- a/arch/arm/configs/at91sam9x5ek_defconfig
+++ b/arch/arm/configs/at91sam9x5ek_defconfig
@@ -65,8 +65,9 @@ CONFIG_NAND=y
 # CONFIG_NAND_ECC_HW_NONE is not set
 CONFIG_NAND_ATMEL=y
 CONFIG_UBI=y
-CONFIG_DISK=y
-CONFIG_DISK_WRITE=y
+CONFIG_MCI=y
+CONFIG_MCI_STARTUP=y
+CONFIG_MCI_ATMEL=y
 CONFIG_LED=y
 CONFIG_LED_GPIO=y
 CONFIG_LED_TRIGGERS=y
-- 
1.7.10.4


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox