From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from metis.ext.pengutronix.de ([2001:67c:670:201:290:27ff:fe1d:cc33]) by bombadil.infradead.org with esmtps (Exim 4.90_1 #2 (Red Hat Linux)) id 1h6sCl-00020n-0f for barebox@lists.infradead.org; Thu, 21 Mar 2019 07:33:36 +0000 Date: Thu, 21 Mar 2019 08:33:32 +0100 From: Sascha Hauer Message-ID: <20190321073332.b3725avve4p6ascg@pengutronix.de> References: <20190320075215.7j36mofzoewd5qfa@pengutronix.de> MIME-Version: 1.0 Content-Disposition: inline In-Reply-To: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: "barebox" Errors-To: barebox-bounces+u.kleine-koenig=pengutronix.de@lists.infradead.org Subject: Re: selected processor does not support `rev r7,r7' To: Lewis Zhou Cc: barebox@lists.infradead.org On Thu, Mar 21, 2019 at 09:03:21AM +0800, Lewis Zhou wrote: > Hi Sascha, > > The toolchain was compiled by crosstool-NG. It used the default config > arm-cortex_a8-linux-gnueabi but with the hardware float enabled. So > the toolchain was arm-cortex_a8-linux-gnueabihf-. Could you add V=1 to your make call and post an example gcc call? one is enough, not the whole output. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox