[PATCH v2 3/4] ARM: nxp-imx8mm-evk: always set up UART

[Lucas Stach <l.stach@pengutronix.de>]

When the TF-A is configured to have some output on the UART it does not
set up the UART on its own, but just expects a pre-existing configuration.
If Barebox did not set up the UART in the !DEBUG_LL case, TF-A will just
hang without any user accessible debug output, which is a very non-obvious
failure, so better be safe and always set up the UART in case TF-A wants
to use it.

Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
---
 arch/arm/boards/nxp-imx8mm-evk/lowlevel.c | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boards/nxp-imx8mm-evk/lowlevel.c b/arch/arm/boards/nxp-imx8mm-evk/lowlevel.c
index cd1f7d168bc6..082aefb8c1c5 100644
--- a/arch/arm/boards/nxp-imx8mm-evk/lowlevel.c
+++ b/arch/arm/boards/nxp-imx8mm-evk/lowlevel.c
@@ -32,9 +32,12 @@ static void setup_uart(void)
 
 	imx8mm_setup_pad(IMX8MM_PAD_UART2_TXD_UART2_TX | UART_PAD_CTRL);
 
-	imx8m_uart_setup_ll();
+	imx8mq_uart_setup((void *)MX8M_UART2_BASE_ADDR);
 
-	putc_ll('>');
+	if (IS_ENABLED(CONFIG_DEBUG_LL)) {
+		imx8m_uart_setup_ll();
+		putc_ll('>');
+	}
 }
 
 static void pmic_reg_write(void *i2c, int reg, uint8_t val)
@@ -157,8 +160,7 @@ static void start_atf(void)
  */
 static __noreturn noinline void nxp_imx8mm_evk_start(void)
 {
-	if (IS_ENABLED(CONFIG_DEBUG_LL))
-		setup_uart();
+	setup_uart();
 
 	start_atf();
 
-- 
2.20.1


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox