[PATCH v1 2/8] ARM: at91: Provide at91_mux_pio_pin for use in lowlevel

[Sam Ravnborg <sam@ravnborg.org>]

Lowlevel init code may wish the ability to configure pins, e.g. for low
level debug UART. The pinctrl-at91 driver already exports an
at91_mux_pin function, but that one is only usable after driver
probe. Instead, provide an at91_mux_pio_pin function, which can be used
at all times.

This is similar to the already existing at91_mux_pio3_pin function

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
---
 arch/arm/mach-at91/include/mach/gpio.h | 25 +++++++++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/arch/arm/mach-at91/include/mach/gpio.h b/arch/arm/mach-at91/include/mach/gpio.h
index ddd6971e3..7f84f41e5 100644
--- a/arch/arm/mach-at91/include/mach/gpio.h
+++ b/arch/arm/mach-at91/include/mach/gpio.h
@@ -151,6 +151,31 @@ static inline int at91_mux_gpio_get(void __iomem *pio, unsigned mask)
 	return (pdsr & mask) != 0;
 }
 
+static inline void at91_mux_pio_pin(void __iomem *pio, unsigned mask,
+				    enum at91_mux mux, int gpio_state)
+{
+	at91_mux_disable_interrupt(pio, mask);
+
+	switch(mux) {
+	case AT91_MUX_GPIO:
+		at91_mux_gpio_enable(pio, mask);
+		break;
+	case AT91_MUX_PERIPH_A:
+		at91_mux_set_A_periph(pio, mask);
+		break;
+	case AT91_MUX_PERIPH_B:
+		at91_mux_set_B_periph(pio, mask);
+		break;
+	default:
+		/* ignore everything else */
+		break;
+	}
+	if (mux != AT91_MUX_GPIO)
+		at91_mux_gpio_disable(pio, mask);
+
+	at91_mux_set_pullup(pio, mask, gpio_state & GPIO_PULL_UP);
+}
+
 static inline void at91_mux_pio3_pin(void __iomem *pio, unsigned mask,
 				     enum at91_mux mux, int gpio_state)
 {
-- 
2.34.1


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox