Dear all,

I am struggling to get networking up and running on my Atmel at91sam9260-ek.

I am trying to use an ASIX USB dongle. I got pretty far. Here is the
console log:

...snip...

barebox 2017.11.0-gdf1d493-dirty #50 Mon Nov 27 17:20:57 CET 2017

...snip...

Board: Atmel at91sam9260-ek
AT91: Detected soc type: at91sam9260
AT91: Detected soc subtype: Unknown

...snip...

usb: USB: scanning bus for devices...
usb: Bus 001 Device 001: ID 0000:0000 OHCI Root Hub
usb: Bus 001 Device 002: ID 0b95:7720 AX88772A
mdio_bus: miibus1: probed
eth1: got preset MAC address: 8c:ae:4c:eb:1f:83
usb: 2 USB Device(s) found

But as soon as I start using the device eth1, the following error
messages appear in the serial console and the dongle LEDs will turn dark.

ping 8.8.8.8
eth1: 100Mbps full duplex link detected
eth1: asix_rx_fixup() Bad Header Length 0xffffffc3, offset 4
eth1: asix_rx_fixup() Bad Header Length 0xd526003c, offset 514
eth1: asix_rx_fixup() Bad Header Length 0x97001127, offset 4
eth1: asix_rx_fixup() Bad Header Length 0xffffffc3, offset 4
T ERROR: OHCI Unrecoverable Error, controller usb-ohci disabled
ERROR: sohci_submit_job failed with -32

Could anyone give me a hint, what to do?

Best regards,

Holger

-- 
Holger Birkmeyer
Ebee Smart Technologies GmbH
Torgauer Str. 12-15
10829 Berlin
Phone: +49 30 6098371-52
Mail: holger.birkmeyer@ebee.berlin