Hello Rolf,

I used this Option already, but to be sure that there is no mistake I 
reconfigured the Barebox and Barebox_MLO again and use the new Version 
2014.07.0. The result is the same.

       LD images/start_am33xx_phytec_phycore_sram.pbl
    arch/arm/boards/built-in-pbl.o: In function `pcm051_board_init':
    :(.text.pcm051_board_init+0x94): undefined reference to
    `__dtb_am335x_phytec_phycore_start'
    make[2]: *** [images/start_am33xx_phytec_phycore_sram.pbl] Error 1
    make[2]: *** Waiting for unfinished jobs....
    make[1]: Leaving directory
    `/phytec/phyBOARD-WEGA-AM335x-PD13.0.0/platform-phyBOARD-WEGA-AM335x/build-target/barebox_mlo-2014.07.0'
    make[1]: *** [images] Error 2
    make: ***
    [/phytec/phyBOARD-WEGA-AM335x-PD13.0.0/platform-phyBOARD-WEGA-AM335x/state/barebox_mlo.compile]
    Error 2

I also attached the config files may be there is an other error?

Regards

Florian



Am 04.07.2014 15:26, schrieb Rolf Evers-Fischer:
> Hi Florian,
>
> [...]
>
> I've had the same problem after updating my beaglebone project to a newer
> barebox version.
>
> Could you please check your barebox configuration?
> The new config item "Allow multiple boards to be selected" in "System
> Type"->"OMAP Features" needs to be selected. After that you should be able to select the "Phytec
> phyCORE pcm051" board.
>
> A rebuild will create a file called "am335x-phytec-phycore-dtb.S" in the
> folder arch/arm/dts. This file contains the missing symbols.
>
> Best regards,
>   Rolf
>