From: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
To: Ezequiel Garcia <ezequiel.garcia@free-electrons.com>,
barebox@lists.infradead.org
Cc: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
Subject: Re: [PATCH 1/2] nand: Add Marvell Orion NAND driver
Date: Tue, 26 Aug 2014 16:09:52 +0200 [thread overview]
Message-ID: <53FC9530.7020009@gmail.com> (raw)
In-Reply-To: <1408825163-6135-2-git-send-email-ezequiel.garcia@free-electrons.com>
On 08/23/2014 10:19 PM, Ezequiel Garcia wrote:
> This commit adds NAND support for the controller present in Kirkwood SoCs.
Ezequiel,
I just did a quick check through all public MVEBU datasheets. It looks
like Kirkwood is really the only SoC with this specific IP while Dove,
Armada 370, and XP have a different one.
> Signed-off-by: Ezequiel Garcia <ezequiel.garcia@free-electrons.com>
> ---
> drivers/mtd/nand/Kconfig | 7 ++
> drivers/mtd/nand/Makefile | 1 +
> drivers/mtd/nand/nand_orion.c | 162 ++++++++++++++++++++++++++++++++++++++++++
> 3 files changed, 170 insertions(+)
> create mode 100644 drivers/mtd/nand/nand_orion.c
>
> diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
> index 04fe3c8..ccf1f9c 100644
> --- a/drivers/mtd/nand/Kconfig
> +++ b/drivers/mtd/nand/Kconfig
> @@ -90,6 +90,13 @@ config NAND_OMAP_GPMC
> Support for NAND flash using GPMC. GPMC is a common memory
> interface found on Texas Instrument's OMAP platforms
>
> +config NAND_ORION
> + bool
> + prompt "Orion NAND driver"
> + depends on ARCH_MVEBU
Therefore, we should limit this to ARCH_KIRKWOOD. Also, we could choose
to call the driver nand_kirkwood.c. OTOH, I am fine with Orion as long
as we find another good name for the other IP. Remember that Dove is
still kind-of-Orion.
FWIW,
Acked-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
I'll give it a try on Guruplug later, too.
> + help
> + Support for the Orion NAND controller, present in Kirkwood SoCs.
> +
> config NAND_ATMEL
> bool
> prompt "Atmel (AT91SAM9xxx) NAND driver"
> diff --git a/drivers/mtd/nand/Makefile b/drivers/mtd/nand/Makefile
> index a1414e1..02dacde 100644
> --- a/drivers/mtd/nand/Makefile
> +++ b/drivers/mtd/nand/Makefile
> @@ -10,6 +10,7 @@ obj-$(CONFIG_MTD_NAND_NOMADIK) += nomadik_nand.o
> obj-$(CONFIG_NAND_IMX) += nand_imx.o
> obj-$(CONFIG_NAND_IMX_BBM) += nand_imx_bbm.o
> obj-$(CONFIG_NAND_OMAP_GPMC) += nand_omap_gpmc.o nand_omap_bch_decoder.o
> +obj-$(CONFIG_NAND_ORION) += nand_orion.o
> obj-$(CONFIG_NAND_ATMEL) += atmel_nand.o
> obj-$(CONFIG_NAND_S3C24XX) += nand_s3c24xx.o
> pbl-$(CONFIG_NAND_S3C24XX) += nand_s3c24xx.o
> diff --git a/drivers/mtd/nand/nand_orion.c b/drivers/mtd/nand/nand_orion.c
> new file mode 100644
> index 0000000..9bdd3b4
> --- /dev/null
> +++ b/drivers/mtd/nand/nand_orion.c
> @@ -0,0 +1,162 @@
> +/*
> + * (C) Copyright 2014, Ezequiel Garcia <ezequiel.garcia@free-electrons.com>
> + *
> + * Based on Orion NAND driver from Linux (drivers/mtd/nand/orion_nand.c):
> + * Author: Tzachi Perelstein <tzachi@marvell.com>
> + *
> + * This file is licensed under the terms of the GNU General Public
> + * License version 2. This program is licensed "as is" without any
> + * warranty of any kind, whether express or implied.
> + */
> +
> +#include <common.h>
> +#include <driver.h>
> +#include <malloc.h>
> +#include <init.h>
> +#include <io.h>
> +#include <of_mtd.h>
> +#include <errno.h>
> +#include <linux/mtd/mtd.h>
> +#include <linux/mtd/nand.h>
> +#include <linux/clk.h>
> +
> +struct orion_nand {
> + struct mtd_info mtd;
> + struct nand_chip chip;
> +
> + u8 ale; /* address line number connected to ALE */
> + u8 cle; /* address line number connected to CLE */
> +};
> +
> +static void orion_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl)
> +{
> + struct nand_chip *chip = mtd->priv;
> + struct orion_nand *priv = chip->priv;
> + u32 offs;
> +
> + if (cmd == NAND_CMD_NONE)
> + return;
> +
> + if (ctrl & NAND_CLE)
> + offs = (1 << priv->cle);
> + else if (ctrl & NAND_ALE)
> + offs = (1 << priv->ale);
> + else
> + return;
> +
> + if (chip->options & NAND_BUSWIDTH_16)
> + offs <<= 1;
> +
> + writeb(cmd, chip->IO_ADDR_W + offs);
> +}
> +
> +static void orion_nand_read_buf(struct mtd_info *mtd, uint8_t *buf, int len)
> +{
> + struct nand_chip *chip = mtd->priv;
> + void __iomem *io_base = chip->IO_ADDR_R;
> + uint64_t *buf64;
> + int i = 0;
> +
> + while (len && (unsigned long)buf & 7) {
> + *buf++ = readb(io_base);
> + len--;
> + }
> + buf64 = (uint64_t *)buf;
> + while (i < len/8) {
> + /*
> + * Since GCC has no proper constraint (PR 43518)
> + * force x variable to r2/r3 registers as ldrd instruction
> + * requires first register to be even.
> + */
> + register uint64_t x asm ("r2");
> +
> + asm volatile ("ldrd\t%0, [%1]" : "=&r" (x) : "r" (io_base));
> + buf64[i++] = x;
> + }
> + i *= 8;
> + while (i < len)
> + buf[i++] = readb(io_base);
> +}
> +
> +static int orion_nand_probe(struct device_d *dev)
> +{
> + struct device_node *dev_node = dev->device_node;
> + struct orion_nand *priv;
> + struct mtd_info *mtd;
> + struct nand_chip *chip;
> + struct clk *clk;
> + void __iomem *io_base;
> + int width, ret;
> + u32 val = 0;
> +
> + priv = xzalloc(sizeof(struct orion_nand));
> + if (!priv) {
> + ret = -ENOMEM;
> + goto no_res;
> + }
> + mtd = &priv->mtd;
> + chip = &priv->chip;
> +
> + io_base = dev_request_mem_region(dev, 0);
> +
> + if (!of_property_read_u32(dev_node, "cle", &val))
> + priv->cle = (u8)val;
> + else
> + priv->cle = 0;
> +
> + if (!of_property_read_u32(dev_node, "ale", &val))
> + priv->ale = (u8)val;
> + else
> + priv->ale = 1;
> +
> + if (!of_property_read_u32(dev_node, "bank-width", &val))
> + width = (u8)val * 8;
> + else
> + width = 8;
> +
> + if (!of_property_read_u32(dev_node, "chip-delay", &val))
> + chip->chip_delay = (u8)val;
> +
> + mtd->parent = dev;
> + mtd->priv = chip;
> + chip->priv = priv;
> + chip->IO_ADDR_R = chip->IO_ADDR_W = io_base;
> + chip->cmd_ctrl = orion_nand_cmd_ctrl;
> + chip->read_buf = orion_nand_read_buf;
> + chip->ecc.mode = NAND_ECC_SOFT;
> +
> + WARN(width > 16, "%d bit bus width out of range", width);
> + if (width == 16)
> + chip->options |= NAND_BUSWIDTH_16;
> +
> + /* Not all platforms can gate the clock, so this is optional */
> + clk = clk_get(dev, 0);
> + if (!IS_ERR(clk))
> + clk_enable(clk);
> +
> + if (nand_scan(mtd, 1)) {
> + ret = -ENXIO;
> + goto no_dev;
> + }
> +
> + add_mtd_nand_device(mtd, "orion_nand");
> + return 0;
> +no_dev:
> + if (!IS_ERR(clk))
> + clk_disable(clk);
> +no_res:
> + free(priv);
> + return ret;
> +}
> +
> +static __maybe_unused struct of_device_id orion_nand_compatible[] = {
> + { .compatible = "marvell,orion-nand", },
> + {},
> +};
> +
> +static struct driver_d orion_nand_driver = {
> + .name = "orion_nand",
> + .probe = orion_nand_probe,
> + .of_compatible = DRV_OF_COMPAT(orion_nand_compatible),
> +};
> +device_platform_driver(orion_nand_driver);
>
_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox
next prev parent reply other threads:[~2014-08-26 14:10 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-08-23 20:19 [PATCH 0/2] mvebu: Openblocks A6 board support Ezequiel Garcia
2014-08-23 20:19 ` [PATCH 1/2] nand: Add Marvell Orion NAND driver Ezequiel Garcia
2014-08-26 14:09 ` Sebastian Hesselbarth [this message]
2014-08-26 16:15 ` Ezequiel Garcia
2014-08-26 18:07 ` Sebastian Hesselbarth
2014-08-26 18:36 ` Sebastian Hesselbarth
2014-08-26 14:28 ` Alexander Aring
2014-08-26 16:06 ` Ezequiel Garcia
2014-09-01 9:33 ` Sascha Hauer
2014-08-23 20:19 ` [PATCH 2/2] ARM: mvebu: Add Plat'home's Kirkwood Openblocks A6 board support Ezequiel Garcia
2014-08-26 14:10 ` Sebastian Hesselbarth
2014-08-26 14:17 ` [PATCH 0/2] mvebu: " Sebastian Hesselbarth
2014-09-01 9:31 ` Sascha Hauer
2014-09-15 19:33 ` Sebastian Hesselbarth
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=53FC9530.7020009@gmail.com \
--to=sebastian.hesselbarth@gmail.com \
--cc=barebox@lists.infradead.org \
--cc=ezequiel.garcia@free-electrons.com \
--cc=thomas.petazzoni@free-electrons.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox