Hello, I am currently trying to bring up barebox for my Beaglebone Black devices. I did an "ARCH=arm CROSS_COMPILE=arm-buildroot-linux-gnueabihf- make am335x_mlo_defconfig”, make and copied resulting barebox-am33xx-beaglebone-mlo.img to MLO into my FAT boot partition. Then I did "ARCH=arm CROSS_COMPILE=arm-buildroot-linux-gnueabihf- make omap3530_beagle_defconfig”, make and copied resulting barebox-beagleboard.img to barebox.bin into my boot FAT. Is the the different prefix in the defconfigs (am33… vs. omap35…) reasonable? Is this approach generally reasonable? Many references in internet to matching defconfigs I found refer to non existing ones, there seems to happen great overhaul meanwhile. I am also asking because, well, it does not work: barebox 2021.05.0-00093-g7689055a8 #2 Fri Jun 11 09:01:36 CEST 2021 Board: TI AM335x BeagleBone detected 'BeagleBone Black' omap-hsmmc 48060000.mmc@0.of: registered as mmc0 omap-hsmmc 481d8000.mmc@0.of: registered as mmc1 booting from MMC mmc1: detected MMC card version 5.1 mmc1: registered mmc1 unable to handle paging request at address 0x4020f010 pc : [<8ffbbd5a>] lr : [<8ffbbd89>] sp : 9ffeffb0 ip : 00000000 fp : 00014e2c r10: 00125920 r9 : 8ffbbce5 r8 : 9ffe4000 r7 : 80000000 r6 : 9fe1a46e r5 : 402f0400 r4 : 8ffbbcdc r3 : 0000060a r2 : 4020f010 r1 : abe742c3 r0 : 80000000 Flags: nzCv IRQs off FIQs on Mode SVC_32 no stack data available This repeats endlessly. I investigated the data sheet and if I am correct 0x4020f010 seems to be a reserved area in L3 memory map. Kind Regards Konsti INSIDE M2M GmbH Konstantin Kletschke Berenbosteler Straße 76 B 30823 Garbsen Telefon: +49 (0) 5137 90950136 Mobil: +49 (0) 151 15256238 Fax: +49 (0) 5137 9095010 konstantin.kletschke@inside-m2m.de http://www.inside-m2m.de Geschäftsführung: Michael Emmert, Ingo Haase, Dr. Fred Könemann, Derek Uhlig HRB: 111204, AG Hannover