barebox for leopardboard
2010-02-05 17:49 UTC (2+ messages)
about the MAINTAINERS file
2010-02-04 8:51 UTC (2+ messages)
newbie problem with kconfig
2010-02-03 21:50 UTC
[PATCH] Documentation/porting.txt: s/barebox/u-boot/ wrongly renamed
2010-02-03 21:27 UTC (2+ messages)
[PATCH] ep93xx eth driver: dump_xxx() cleanup
2010-02-03 11:12 UTC (2+ messages)
[PATCH] ep93xx eth driver: Remove unnecessary parentheses in constant definitions
2010-02-02 18:16 UTC
[PATCH] ep93xx eth driver: Reorder functions to eliminate need for prototypes
2010-02-02 7:37 UTC (2+ messages)
[PATCH] ep93xx eth driver: Fix dump_xxx_queue() parameter list
2010-02-02 7:36 UTC (2+ messages)
[PATCH 0/2] smc91111 mac address and cfi flash fixes
2010-02-01 15:31 UTC (4+ messages)
` [PATCH 1/2] smc91111: fix odering of mac address read from EEPROM
` [PATCH 2/2] cfi_flash: fix alignment problem
barebox.2010.02.0 is out
2010-02-01 15:25 UTC
[PATCH] i.MX35: Fix pad control bit positions
2010-01-29 11:51 UTC
[PATCH 1/1] Fix nand_imx for i.MX21
2010-01-29 8:33 UTC (2+ messages)
[PATCH] mach-at91: reset_cpu: fix confusing reference to watchdog
2010-01-26 18:01 UTC (2+ messages)
Patches for -next
2010-01-25 8:57 UTC (15+ messages)
` [PATCH 01/12] remove unused cdp code
` [PATCH 02/12] remove obsolete comment
` [PATCH 03/12] cache functions from kernel
` [PATCH 04/12] remove unused NETCONSOLE stuff
` [PATCH 05/12] remove unused file common/flash.c
` [PATCH 06/12] Move tftp/nfs specific code to net/*
` [PATCH 07/12] remove typedef cmd_tbl_t and replace it with struct command
` [PATCH 08/12] pcm043: initialize cpufreq to 532MHz
` [PATCH 09/12] replace ET_DEBUG with pr_debug
` [PATCH 10/12] put only once used function inline
` [PATCH 11/12] add armv6 support to the konfig system
` [PATCH 12/12] i.MX: select armv6 for i.MX31/35
[PATCH] Fix typo in board.dox
2010-01-25 7:49 UTC (4+ messages)
Current status of barebox for OMAP3530/beagle
2010-01-22 21:57 UTC (3+ messages)
Current status of barebox for OMAP3530/beagle
2010-01-22 17:34 UTC
Barbox in OpenEmbedded
2010-01-22 16:35 UTC
[PATCH] arm cache fixes
2010-01-22 15:14 UTC (3+ messages)
` [PATCH 1/2] give nice output when generating barebox.bin and barebox.S
` [PATCH 2/2] arm: make disabling the cache actually work
[PATCH 0/8] update i.MX35 3stack and i2c drivers
2010-01-19 8:26 UTC (10+ messages)
` [PATCH 1/8] mc9sdz60: clean up driver interface
` [PATCH 2/8] mc13892: "
` [PATCH 3/8] i.MX35 3stack: adopt board to new mc13892 and mc9sdz60 "
` [PATCH 4/8] i.MX35 3stack: clean up indention
` [PATCH 5/8] i.MX35 3stack: clean up indention of lowlevel_init
` [PATCH 6/8] i.MX35 3stack: increase env partition to hold splash image
` [PATCH 7/8] i.MX35 3stack: update environemnt to support jffs and ubi/ubifs
` [PATCH 8/8] i.MX35 3stack: update of defconfig
[PATCH 1/4] eukrea_cpuimx27 : update timings
2010-01-16 11:33 UTC (5+ messages)
` [PATCH 2/4] Add necessary clocks & defines to get I2C support for i.MX27
` [PATCH 3/4] I2C : add NS LP3972 PMIC support
` [PATCH 4/4] Eukrea CPUIMX27 : add I2C and LP3972 support
[PATCH] documentation: It's U-Boot that doesn't have getopt, not Barebox
2010-01-16 11:31 UTC (2+ messages)
[PATCHv3] addpart: support @<offset>
2010-01-16 11:30 UTC (2+ messages)
[PATCHV2] addpart: support @<offset>
2010-01-15 13:43 UTC (2+ messages)
[PATCH] addpart: support @<offset>
2010-01-15 13:26 UTC
compiling barebox/u-boot-v2 for beagleboard
2010-01-15 8:05 UTC (2+ messages)
[PATCH 0/5] Add support for EDB93xx boards [rev2]
2010-01-14 9:29 UTC (2+ messages)
[PATCHv2 00/14] Bring in basic x86 support into 'barebox'
2010-01-14 9:29 UTC (16+ messages)
` [PATCHv2 01/14] Add a tool to activate barebox as a boot loader on x86 architectures
` [PATCHv2 02/14] Consider real and protected mode in the dump file
` [PATCHv2 03/14] Adding x86 usage documentation to the tree
` [PATCHv2 04/14] Adding required architecture header files
` [PATCHv2 05/14] Bring in the first x86 specific code
` [PATCHv2 06/14] Add some generic functions to make x86 work
` [PATCHv2 07/14] Add functions to be able to boot with BIOSs help
` [PATCHv2 08/14] Add a generic PC platform
` [PATCHv2 09/14] Bring in the time reference for the x86 platforms
` [PATCHv2 10/14] Start to add ATA support to barebox
` [PATCHv2 11/14] Add the main disk driver
` [PATCHv2 12/14] Add a low level disk drive access driver
` [PATCHv2 13/14] Add a special command to load and start a bzImage on x86
` [PATCHv2 14/14] Add the whole x86 architecture to the build system
[PATCH 5/5] Add support for EDB93xx boards
2010-01-12 19:30 UTC
[PATCH 4/5] Add PrimeCell PL010 serial driver
2010-01-12 19:30 UTC
[PATCH 3/5] Add support for EP9xx GPIOs
2010-01-12 19:30 UTC
[PATCH 2/5] Add EP93xx ethernet driver
2010-01-12 19:30 UTC
[PATCH 1/5] ARM: Add support for EP93xx SoCs
2010-01-12 19:30 UTC
[PATCH 0/5] Add support for EDB93xx boards
2010-01-12 19:30 UTC (7+ messages)
` [PATCH] Add support for EDB93xx boards [rev2]
[PATCH 2/5] Add EP93xx ethernet driver
2010-01-11 21:27 UTC (3+ messages)
` [PATCH] Add EP93xx ethernet driver [rev2]
[PATCH] Fix a data abort with fec_imx
2010-01-11 17:58 UTC (2+ messages)
[PATCH 5/5] Add support for EDB93xx boards
2010-01-09 23:29 UTC
[PATCH 4/5] Add PrimeCell PL010 serial driver
2010-01-09 23:29 UTC
[PATCH 3/5] Add support for EP9xx GPIOs
2010-01-09 23:28 UTC
[PATCH 1/5] ARM: Add support for EP93xx SoCs
2010-01-09 23:28 UTC
Query on default environment
2010-01-08 9:18 UTC (2+ messages)
[PATCH 0/2] CFI flash drivers: Fix misleading trace when unprotecting a sector
2010-01-05 12:15 UTC (2+ messages)
confusion about relocation (ARM)
2010-01-04 21:10 UTC (7+ messages)
[PATCH 2/2] New CFI flash driver: Fix misleading trace when unprotecting a sector
2010-01-04 19:42 UTC
[PATCH 1/2] CFI flash driver: Fix misleading trace when unprotecting a sector
2010-01-04 19:42 UTC
[PATCH 0/1] Exclude code based on config
2010-01-04 16:18 UTC (4+ messages)
` [PATCH 1/1] net: Exclude code based on selected protocol
[PATCH] fix path specs in arch/arm/mach-arm.dox
2010-01-04 10:12 UTC (2+ messages)
i.MX25 NAND status
2009-12-29 11:30 UTC (4+ messages)
barebox-2009.12.0 is out
2009-12-25 15:07 UTC (9+ messages)
[PATCHv2 1/1] net: Exclude code based on selected protocol
2009-12-24 14:05 UTC
building for sandbox, warning: "__BIG_ENDIAN" is not defined
2009-12-23 10:50 UTC (4+ messages)
which drivers subdirs should be automatically selected?
2009-12-23 9:19 UTC (6+ messages)
[PATCH] Fix typo, "CFG_LONGHELP" -> "CONFIG_LONGHELP"
2009-12-23 9:06 UTC (3+ messages)
PROPOSED patch, standardize drivers menuconfig entries
2009-12-22 16:54 UTC (2+ messages)
[PATCH] drivers: use "menuconfig" consistently for all selections
2009-12-22 14:52 UTC (3+ messages)
can someone explain this CONFIG_COMMANDS, CFG_CMD thing?
2009-12-21 16:23 UTC (2+ messages)
barebox on twitter?
2009-12-21 16:03 UTC
anyone object to my making some menuconfig options 1-touch selectable?
2009-12-21 15:14 UTC
[PATCH] Remove PPC support for IDE
2009-12-21 14:26 UTC (2+ messages)
[PATCH] Remove obsolete comment referring to CFG_CMD_JFFS2
2009-12-21 14:26 UTC (2+ messages)
[PATCH repeat] MTD: Correct typo in preprocessor directive
2009-12-21 14:24 UTC (2+ messages)
more CONFIG oddities in the current barebox tree
2009-12-21 13:56 UTC (6+ messages)
[PATCH] Remove/adjust erroneous references to CONFIG_MODULE
2009-12-21 13:22 UTC (2+ messages)
[PATCH] commands: Remove reference to non-existent CONFIG_CMD_I2C
2009-12-21 11:54 UTC (6+ messages)
[PATCH] scripts: Delete non-barebox content from scripts/
2009-12-21 11:11 UTC (3+ messages)
[PATCH] commands: correct "CONFIG_SIMPLE_PARSER" to "CONFIG_SHELL_SIMPLE"
2009-12-21 10:50 UTC (2+ messages)
[PATCH] NAND: Free asprintf()-allocated space upon mtd device deletion
2009-12-21 10:50 UTC (2+ messages)
possible memory leak in commands/nand.c?
2009-12-21 10:16 UTC (4+ messages)
can barebox avoid creating typedefs just for struct shortcuts?
2009-12-21 10:04 UTC (2+ messages)
the "CONFIG_" namespace and what's with "CFG_CMD_" prefixes?
2009-12-21 10:01 UTC (2+ messages)
apparently unused <linux/...> header files
2009-12-21 9:49 UTC
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox