[PATCH 00/21] PCIe support for i.MX7
2019-01-12 4:24 UTC (27+ messages)
` [PATCH 01/21] regulator: Convert drivers to use struct regulator_desc
` [PATCH 02/21] regulator: Port basic regmap regulator functions
` [PATCH 03/21] regulator: Add support for setting regulator's voltage
` [PATCH 04/21] base: driver: Drop redundant list_empty() check
` [PATCH 05/21] base: Port driver_deferred_probe_check_state() from Linux
` [PATCH 06/21] regulator: Add primitive support for deferred probe
` [PATCH 07/21] regulator: Port ANATOP driver from Linux
` [PATCH 08/21] drivers: base: Port power management code "
` [PATCH 09/21] soc: imx: Add GPCv2 power gating driver
` [PATCH 10/21] soc: imx: gpcv2: fix regulator deferred probe
` [PATCH 11/21] soc: imx: gpcv2: correct PGC offset
` [PATCH 12/21] reset: Add i.MX7 SRC reset driver
` [PATCH 13/21] reset: imx7: Fix always writing bits as 0
` [PATCH 14/21] reset: Mark local functions as static
` [PATCH 15/21] PCI: imx6: Add code to support i.MX7D
` [PATCH 16/21] PCI: imx6: Allow probe deferral by reset GPIO
` [PATCH 17/21] PCI: imx6: Do not wait for speed change on i.MX7
` [PATCH 18/21] PCI: imx6: Do not switch speed if Gen2 is disabled
` [PATCH 19/21] PCI: imx6: Fix spelling mistake: "contol" -> "control"
` [PATCH 20/21] PCI: imx6: Drop unnecessary root_bus_nr setting
` [PATCH 21/21] PCI: imx6: Port imx6_pcie_ltssm_enable()
[PATCH 00/21] PCI improvements
2019-01-12 2:34 UTC (26+ messages)
` [PATCH 01/21] PCI: Switch to using %pa to print memory addresses
` [PATCH 02/21] PCI: Replace last_* variables with an array
` [PATCH 03/21] PCI: Consolidate limit/base settting code
` [PATCH 04/21] PCI: Convert prescan_setup_bridge() to use a loop
` [PATCH 05/21] PCI: Convert postscan_setup_bridge() "
` [PATCH 06/21] PCI: Replace magic number in setup_device()
` [PATCH 07/21] PCI: Remove superfluous parens "
` [PATCH 08/21] PCI: Simplify resource setup code "
` [PATCH 09/21] PCI: Store and reuse BAR offsets
` [PATCH 10/21] PCI: Conver register_pci_controller() to use a loop
` [PATCH 11/21] PCI: Remove unused variables/code
` [PATCH 12/21] PCI: Make pci_scan_bus static
` [PATCH 13/21] PCI: Drop "slots" from struct pci_bus
` [PATCH 14/21] PCI: Drop "resources" "
` [PATCH 15/21] PCI: Drop "name" "
` [PATCH 16/21] PCI: Drop "ops" "
` [PATCH 17/21] PCI: Drop "rom_address" from struct pci_dev
` [PATCH 18/21] PCI: Simplify alloc_pci_dev()
` [PATCH 19/21] PCI: Assume 1:1 mapping if .res_start callback is NULL
` [PATCH 20/21] PCI: Convert ->res_start() to return resource_size_t
` [PATCH 21/21] PCI: Consify pci_ops in struct pci_controller
[PATCH 1/3] Documentation: i.MX: improve wording, add markup and missing articles
2019-01-11 11:35 UTC (5+ messages)
build barebox for imx8mqevk
2019-01-11 11:13 UTC (2+ messages)
[PATCH] ARM: i.MX8MQ: Add alias for ECSPI1
2019-01-11 11:07 UTC (2+ messages)
[PATCH] ARM: nitrogen6x: remove conflicting upstream SPI NOR partitions
2019-01-11 11:07 UTC (2+ messages)
[PATCH RFC] imx6ul-phytec-phycore-som: don't use fsl, no-blockmark-swap for the NAND
2019-01-11 11:03 UTC (3+ messages)
` [PATCH RFC] imx6ul-phytec-phycore-som: don't use fsl,no-blockmark-swap "
dfu: Does is work for anybody with dfu-util 0.9?
2019-01-11 11:02 UTC (2+ messages)
barebox: plathome-openblocks-a6/kwbimage.cfg is missed
2019-01-11 8:23 UTC (2+ messages)
[RFC] ARM: zynq: fix "'IO_SPACE_LIMIT' redefined" warning
2019-01-10 11:01 UTC (5+ messages)
[PATCH 0/3] drivers: fix "no previous prototype" warnings
2019-01-10 8:33 UTC (5+ messages)
` [PATCH 1/3] w1: fix "no previous prototype for 'w1_found'" warning
` [PATCH 2/3] serial: amba-pl011: fix "no previous prototype for 'pl011_init_port'" warning
` [PATCH 3/3] net: ks8851_mll: fix "no previous prototype for 'ks_enable_qmu'" warning
[PATCH 3/5] usbgadget: dfu: remove useless break in the switch statement
2019-01-10 8:32 UTC (2+ messages)
[PATCH] mtd: core: Fix erase area alignment for non power of 2 erasesize
2019-01-10 8:32 UTC (2+ messages)
[HELP] Barebox porting
2019-01-09 13:03 UTC (2+ messages)
[PATCH] printk: Pass groupsize to memory_display() in print_hex_dump()
2019-01-09 7:26 UTC (2+ messages)
[PATCH] mfd: syscon: Switch to using %pa to print memory addresses
2019-01-09 7:25 UTC (2+ messages)
[PATCH] memory_display: Fix type of argument passed to %*s
2019-01-09 7:25 UTC (2+ messages)
[PATCH] fixup! arm: fix no prototype for barebox_arm_reset_vector()
2019-01-09 7:23 UTC (2+ messages)
[PATCH 1/6] dp83867: port from linux
2019-01-09 7:22 UTC (7+ messages)
` [PATCH 2/6] macb: fix format specifiers for debug output
` [PATCH 3/6] macb: fix check if hw is gem
` [PATCH 4/6] macb: fix memory leakage due to double allocation of rx_buffer
` [PATCH 5/6] macb: disable second priority queue for zynqmp gem support
` [PATCH 6/6] zynqmp: enable macb Ethernet support
[PATCH 0/3] add at91 documentation
2019-01-08 15:41 UTC (5+ messages)
` [PATCH v1 1/3] doc: "
` [PATCH v1 2/3] doc: add additional at91 boards
` [PATCH v1 3/3] doc: at91sam9263-ek: add notes
[PATCH 1/2] recursive_action: add ACTION_SORT flag
2019-01-08 15:40 UTC (9+ messages)
` [PATCH v2 "
` [PATCH 1/2] envfs: fix problem #1
` [PATCH 2/2] envfs: fix problem #2
[PATCH v2 00/65] PCI i.MX6/DesignWare sync up with 4.20-rc1
2019-01-08 15:31 UTC (3+ messages)
[PATCH] common: state: fix alignment
2019-01-08 15:18 UTC (4+ messages)
` [PATCH] common: state: fix another alignment
[PATCH 01/10] serial: clps711x: Change compatible string
2019-01-08 10:45 UTC (5+ messages)
` [PATCH 02/10] serial: clps711x: Switch to SPDX identifier
[PATCH 0/4] arm: boards: phytec-som-am335x: Add bootchooser support
2019-01-08 7:37 UTC (6+ messages)
` [PATCH 1/4] ARM: configs: omap_defconfig: Add bootchooser
` [PATCH 2/4] ARM: dts: am335x-phytec-state: Reduce partition size
` [PATCH 3/4] ARM: dts: am335x-phytec-state: Add state partition for bootchooser
` [PATCH 4/4] arm: boards: phytec-som-am335x: Add bootchooser to bootsource
[PATCH 00/23] AM3517 support
2019-01-07 11:46 UTC (4+ messages)
` [PATCH 22/23] ARM: omap: Add board support for WAGO pfc200 platform
unalignment access on cortex-a8 caues exception
2019-01-07 11:02 UTC (2+ messages)
[PATCH v1 1/1] Add generic implementation for muldi3
2019-01-07 8:16 UTC (3+ messages)
[PATCH v3 00/10] Add initial RISC-V architecture support
2019-01-07 7:54 UTC (4+ messages)
[PATCH 0/5] Independent collection of patches
2019-01-07 7:41 UTC (10+ messages)
` [PATCH v1 1/5] 2d-primitives: fix no previous prototype warning
` [PATCH v1 2/5] images: fix force rebuild of piggy.o
` [PATCH v1 3/5] arm: fix no prototype for barebox_arm_reset_vector()
` [PATCH v1 4/5] at91sam9263ek: fix build of of_init
` [PATCH v1 5/5] video: mtl017: fix driver name variable
[PATCH 0/9] net: Allow global.net.server being a hostname
2019-01-07 7:40 UTC (10+ messages)
` [PATCH 1/9] net: ip_route_get: Fix error message
` [PATCH 2/9] net: ip_route_get: Hook help text to command
` [PATCH 3/9] net: dns: leave host command with error on failure
` [PATCH 4/9] net: dns: Allow to set variable with the resolved host
` [PATCH 5/9] defaultenv: Pass serverip to nfsroot string
` [PATCH 6/9] net: Allow hostnames for global.net.server
` [PATCH 7/9] net: ip_route_get: resolv hostnames
` [PATCH 8/9] defaultenv: defaultenv uses ip_route_get
` [PATCH 9/9] defaultenv: resolve global.net.server before using it
[PATCH v1 0/3] bootstrap support for AT91SAM9263-EK
2019-01-07 7:29 UTC (15+ messages)
` [PATCH v1 1/3] arm: at91: fix clock to mci1 for at91sam9263
` [PATCH v1 2/3] lib: bootstrap: detect SD card before mounting
` [PATCH v1 3/3] at91sam9263ek: add bootstrap support
[PATCH 1/4] net/e1000: Map custom error codes to more appropriate errno values
2019-01-04 11:16 UTC (4+ messages)
barebox on Canon A1100
2019-01-04 10:54 UTC (3+ messages)
[PATCH] of: Add .of suffix to device names from devicetree
2019-01-04 8:12 UTC (3+ messages)
[PATCH] ARM: imx7: missing config for AIPS3 bridge added
2019-01-03 11:18 UTC (2+ messages)
[PATCH] README: add licensing information
2019-01-03 11:05 UTC (2+ messages)
[PATCH] imd: model and compatible missing in metadata
2019-01-03 11:02 UTC (5+ messages)
[PATCH] nvmem: ocotp: Fix writing of second mac address fuses on imx6ul
2019-01-03 11:01 UTC (2+ messages)
[PATCH v2 1/3] MIPS: migrate all files to SPDX
2019-01-03 10:07 UTC (2+ messages)
MIPS multiimabe is brocken after "Images: Add image size to built images"
2019-01-03 10:04 UTC (7+ messages)
[PATCH V3 1/2] mfd: mc13892: MC13892_POWER_MISC bits revision
2019-01-03 9:41 UTC (2+ messages)
[PATCH] fs/fat: fix FAT32 detection
2019-01-03 9:27 UTC (2+ messages)
[PATCH 1/2] imx-bbu-nand-fcb: Check the required space a bit earlier
2019-01-03 9:24 UTC (2+ messages)
[PATCH] Documentation: imx8mq-evk: Pass the full path for file names
2019-01-03 9:20 UTC (2+ messages)
[PATCH 00/11] Sync Kconfig to Linux 4.20
2019-01-03 9:18 UTC (13+ messages)
` [PATCH 02/11] kbuild: add .DELETE_ON_ERROR special target
` [PATCH 03/11] kbuild: add .SECONDARY "
` [PATCH 04/11] kbuild: add %.lex.c and %.tab.[ch] to 'targets' automatically
` [PATCH 09/11] kbuild: generate lexer and parser during build instead of shipping
` [PATCH 10/11] kconfig: sync to Linux 4.20
[PATCH] mci: skip of_partitions_register_fixup for boot partitions
2019-01-03 8:17 UTC (2+ messages)
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox