[PATCH v2 00/13] prepare Protonic board code for mainline
2020-08-11 11:12 UTC (18+ messages)
` [PATCH v2 01/13] ARM: dts: imx6q-prti6q: fix PHY register
` [PATCH v2 02/13] ARM: dts: imx6: vicut1: fix network support
` [PATCH v2 03/13] of: base: register DT root as device
` [PATCH v2 04/13] ARM: embest-riotboard: port board file to the driver model
` [PATCH v2 05/13] net: port nvmem_get_mac_address() from linux kernel
` [PATCH v2 06/13] of: of_net: sync of_get_mac_address() with latest kernel version
` [PATCH v2 07/13] net: fec_imx: use of_get_mac_address() to get mac address out of DT
` [PATCH v2 08/13] of: of_device_get_match_compatible() helper
` [PATCH v2 09/13] gpiolib: add gpio_array_to_id helper to get ID out of GPIO array
` [PATCH v2 10/13] common: console_common: add of_console_get_by_alias() helper
` [PATCH v2 11/13] ARM: protonic-imx6: port Protonic specific board code
` [PATCH v2 12/13] of: add barebox-serial driver
` [PATCH v2 13/13] ARM: dts: imx6q-prti6q: add barebox, serial-number node
[PATCH v2 1/4] ARM: imx8mm: select FIRMWARE_IMX_LPDDR4_PMU_TRAIN from IMX8MM_EVK
2020-08-11 9:43 UTC (4+ messages)
` [PATCH v2 2/4] ARM: imx8m: make debug UART selection available on i.MX8MM/MP
` [PATCH v2 3/4] ARM: nxp-imx8mm-evk: always set up UART
` [PATCH v2 4/4] nvmem: ocotp: add support for i.MX8MM
[PATCH v3 00/14] usb: dwc2: Add host and gadget driver
2020-08-11 9:31 UTC (23+ messages)
` [PATCH v3 01/14] Revert "usb: Add dwc2 host driver"
` [PATCH v3 02/14] usb: dwc2: Add host controller driver
` [PATCH v3 03/14] usb: dwc2: host: Read dr_mode from device tree
` [PATCH v3 04/14] usb: dwc2: Rework roothub interface
` [PATCH v3 05/14] usb: dwc2: Rework timeout
` [PATCH v3 06/14] usb: dwc2: host: Handle dma mapping errors
` [PATCH v3 07/14] usb: dwc2: host: Dynamic fifo size support from Linux
` [PATCH v3 08/14] usb: dwc2: host: Fix toggle reset
` [PATCH v3 09/14] usb: dwc2: host: Rewrite dwc2_hc_init
` [PATCH v3 10/14] usb: dwc2: Add function to flush tx fifo
` [PATCH v3 11/14] usb: dwc2: Add structure for gadget driver
` [PATCH v3 12/14] usb: dwc2: Add "
` [PATCH v3 13/14] usb: dwc2: Use register_otg_device
` [PATCH v3 14/14] usb: dwc2: Add ulpi phy function
[PATCH] console_countdown: Add CR as valid return key
2020-08-11 9:29 UTC (3+ messages)
[PATCH v1 00/11] prepare Protonic board code for mainline
2020-08-11 8:27 UTC (21+ messages)
` [PATCH v1 01/11] ARM: dts: imx6q-prti6q: fix PHY register
` [PATCH v1 02/11] of: base: register DT root as device
` [PATCH v1 03/11] ARM: embest-riotboard: port board file to the driver model
` [PATCH v1 04/11] net: port nvmem_get_mac_address() from linux kernel
` [PATCH v1 05/11] of: of_net: sync of_get_mac_address() with latest kernel version
` [PATCH v1 06/11] net: fec_imx: use of_get_mac_address() to get mac address out of DT
` [PATCH v1 07/11] of: of_device_get_match_compatible() helper
` [PATCH v1 08/11] gpiolib: add gpio_array_to_id helper to get ID out of GPIO array
` [PATCH v1 09/11] ARM: protonic-imx6: port protonic specific board code
` [PATCH v1 10/11] of: add barebox-serial driver
` [PATCH v1 11/11] ARM: dts: imx6q-prti6q: add barebox.serial node
[PATCH v5] FIT: Parse `load` and `entry` addresses
2020-08-11 7:57 UTC (5+ messages)
[PATCH] arm: baltos: export DIP switch value
2020-08-11 7:39 UTC (3+ messages)
[PATCH] kvx: exclude dtb from malloc zone
2020-08-11 7:34 UTC (5+ messages)
Some USB memory sticks not (fully) recognized
2020-08-11 6:33 UTC (5+ messages)
[PATCH] ARM: boards: phytec-som-imx6: Add mmc and emmc-boot bbu update handler
2020-08-10 20:00 UTC (2+ messages)
[PATCH 1/5] clk: imx7: add IMX7D_OCOTP_CLK
2020-08-10 19:54 UTC (2+ messages)
[PATCH v2] arm: baltos: add environment node
2020-08-10 19:48 UTC (2+ messages)
[PATCH] treewide: remove stale instances of struct device
2020-08-10 19:30 UTC (4+ messages)
[PATCH v3] bootm: add global.bootm.root_dev env var for booting via PARTUUID
2020-08-10 12:20 UTC
[PATCH v2] bootm: add global.bootm.root_dev env var for booting via PARTUUID
2020-08-10 12:14 UTC
[PATCH] bootm: add global.bootm.root_dev env var for booting via PARTUUID
2020-08-10 12:08 UTC
[PATCH 00/11] ramfs: Use dynamically sized chunks
2020-08-10 11:13 UTC (4+ messages)
` [PATCH 04/11] fs: free inodes we no longer need
[PATCH 0/3] squashfs: Fix current master
2020-08-10 11:12 UTC (4+ messages)
` [PATCH 1/3] fs: squashfs: set s_op in time
` [PATCH 2/3] fs: squashfs: Do not free root inode
` [PATCH 3/3] fs: Use iget_locked() rather than squashfs specific function
[RFC PATCH v2 0/3] Introduce global.bootm.root_dev env var for booting via PARTUUID
2020-08-10 9:45 UTC (6+ messages)
` [RFC PATCH v2 1/3] bootm: add env var root_dev
` [RFC PATCH v2 2/3] globalvar: add bootm.root_dev
` [RFC PATCH v2 3/3] bootm: handle global.bootm.root_dev
[PATCH v2 0/2] ARM: i.MX: Add support for IMX7 based board
2020-08-10 9:33 UTC (7+ messages)
` [PATCH v2 1/2] mci: imx-esdhc-pbl: Add support for IMX7
` [PATCH v2 2/2] ARM: i.MX: Add atlascopco sxb board
[PATCH 1/3] ARM: i.MX6 dtsi: add enet_out clock
2020-08-10 8:38 UTC (5+ messages)
` [PATCH 2/3] ARM: imx6ul: add fec bits to GPR syscon definition
` [PATCH 3/3] ARM: i.MX: setup ENET_CLK_SEL in imx6_init for every imx6q/imx6d
Getting serial console output on new imx7d tqma7 board UART4
2020-08-10 8:00 UTC (20+ messages)
[PATCH] spi: add coredevice_spi_driver macro as well
2020-08-10 6:38 UTC (2+ messages)
[PATCH] image: Convert the IH_... values to enums
2020-08-10 6:36 UTC (3+ messages)
` [PATCH] riscv: Makefile: make it possible to use riscv64 compiler
[PATCH 0/2] ARM: i.MX: Add support for IMX7 based board
2020-08-03 22:28 UTC (4+ messages)
` [PATCH 1/2] mci: imx-esdhc-pbl: Add support for IMX7
` [PATCH 2/2] ARM: i.MX: Add atlascopco sxb board
[PATCH] USB: gadget: Add serialnumber device parameter
2020-08-03 21:41 UTC (2+ messages)
[PATCH] startup: Add missing newline to notice message
2020-08-03 21:38 UTC (2+ messages)
[PATCH 1/3] i2c: sync i2c_parse_fw_timings() with upstream
2020-08-03 21:33 UTC (4+ messages)
` [PATCH 2/3] i2c: at91: extend for sama5d2 support
` [PATCH 3/3] mfd: add Atmel Flexcom support
[PATCH] ARM: at91: pass along bootsource to netbooted barebox
2020-08-03 21:26 UTC (2+ messages)
[PATCH 1/2] ratp: Abort console_countdown when activated
2020-08-03 21:23 UTC (3+ messages)
` [PATCH 2/2] ratp: Remove duplicated includes
[PATCH] add untar command
2020-08-03 19:58 UTC (2+ messages)
[PATCH 1/4] ARM: imx8mm: select FIRMWARE_IMX_LPDDR4_PMU_TRAIN from IMX8MM_EVK
2020-08-03 19:36 UTC (5+ messages)
` [PATCH 2/4] ARM: imx8m: make debug UART selection available on i.MX8MM
` [PATCH 3/4] ARM: nxp-imx8mm-evk: always set up UART
` [PATCH 4/4] nvmem: ocotp: add support for i.MX8MM
[PATCH] gpio: get function returns masked register value
2020-08-03 19:20 UTC (2+ messages)
[PATCH master] i2c: stm32: support new st,stm32mp15-i2c compatible
2020-08-03 19:19 UTC (2+ messages)
[PATCH] scripts/rsatoc: fix printing of error message, if environment variable doen't contain a path
2020-08-03 19:18 UTC (2+ messages)
[PATCH] Documentation/sandbox: fix code block
2020-08-03 19:16 UTC (2+ messages)
[PATCH] ARM: stm32mp: add support for Seeed Odyssey board
2020-08-03 19:15 UTC (2+ messages)
[PATCH] ARM: socfpga: achilles: remove unused barebox,bootstate node
2020-08-03 19:02 UTC (2+ messages)
[PATCH] net:fec: fixed unaligned access and stack corruption
2020-07-30 21:33 UTC (9+ messages)
gpio generic driver
2020-07-24 8:40 UTC (3+ messages)
tar command support
2020-07-24 5:35 UTC
[PATCH v1] gpiolib: add gpio_array_to_id helper to get ID out of GPIO array
2020-07-23 6:25 UTC (2+ messages)
[PATCH 1/2] phy: stm32-usphyc: release resources to properly support EPROBE_DEFER
2020-07-22 8:09 UTC (2+ messages)
` [PATCH 2/2] regulator: stm32-pwr: "
[PATCH v4 0/3] introduce board-driver support
2020-07-20 8:35 UTC (5+ messages)
` [PATCH v4 1/3] devinfo: do not dump the device node for the root node
` [PATCH v4 2/3] of: base: register DT root as device
` [PATCH v4 3/3] ARM: embest-riotboard: port board file to the driver model
[PATCH] dtc_cpp: allow to pass options per target
2020-07-20 6:43 UTC
[PATCH v2 0/3] introduce board-driver support
2020-07-17 4:11 UTC (5+ messages)
` [PATCH v3 1/3] devinfo: do not dump the device node for the root node
` [PATCH v3 3/3] ARM: embest-riotboard: port board file to the driver model
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox